RIGOL DP832A - Manual (Page 118)

RIGOL Chapter 2 Command System
2-94 DP800 Programming Guide
[:SOURce[]]:VOLTage:PROTection[:LEVel]
Syntax [:SOURce[]]:VOLTage:PROTection[:LEVel] {|MINimum|MAXimum}
[:SOURce[]]:VOLTage:PROTection[:LEVel]? [{MINimum|MAXimum}]
Description Set the overvoltage protection (OVP) value of the specified channel.
Query the overvoltage protection (OVP) value of the specified channel.
Parameter Name Type Range Default
[] Integer 1|2|3 1
Real Refer to Table 2-2
Explanation  When the overvoltage protection function of the specified channel is enabled
( [:SOURce[]]:VOLTage:PROTection:STATe ), the output turns off
automatically when the output voltage exceeds the overvoltage protection limit
currently set. You can send the
[:SOURce[]]:VOLTage:PROTection:TRIPped? command to query whether
overvoltage protection occurred on the specified channel currently.
 When [:SOURce[]] or [] is omitted, the system sets the
corresponding parameter of the channel currently selected.
 You can also send the :OUTPut:OVP:VALue command to set the OVP value of
the specified channel.
Return Format The query returns the overvoltage protection value of the specified channel, for
example, 8.800.
Example :VOLT:PROT 8.8 /*Set the OVP value of the current channel to 8.8V*/
:VOLT:PROT? /*Query the OVP value of the current channel and the query
returns 8.800*/
Related
Commands
[:SOURce[]]:VOLTage:PROTection:STATe
[:SOURce[]]:VOLTage:PROTection:TRIPped?
:OUTPut:OVP:VALue