RIGOL DP832A - Manual (Page 106)

RIGOL Chapter 2 Command System
2-82 DP800 Programming Guide
:SOURce Commands
The :SOURce commands are used to set the voltage, current, OVP and OCP values of the specified channel.
Although the :APPLy command provides the most straightforward method to program the power supply
over the remote interfaces, the :SOURce commands give you more flexibility to change individual
parameters.
Command List:
 [:SOURce[]]:CURRent[:LEVel][:IMMediate][:AMPLitude]
 [:SOURce[]]:CURRent[:LEVel][:IMMediate]:STEP[:INCRement]
 [:SOURce[]]:CURRent[:LEVel]:TRIGgered[:AMPLitude]
 [:SOURce[]]:CURRent:PROTection:CLEar
 [:SOURce[]]:CURRent:PROTection[:LEVel]
 [:SOURce[]]:CURRent:PROTection:STATe
 [:SOURce[]]:CURRent:PROTection:TRIPped?
 [:SOURce[]]:VOLTage[:LEVel][:IMMediate][:AMPLitude]
 [:SOURce[]]:VOLTage[:LEVel][:IMMediate]:STEP[:INCRement]
 [:SOURce[]]:VOLTage[:LEVel]:TRIGgered[:AMPLitude]
 [:SOURce[]]:VOLTage:PROTection:CLEar
 [:SOURce[]]:VOLTage:PROTection[:LEVel]
 [:SOURce[]]:VOLTage:PROTection:STATe
 [:SOURce[]]:VOLTage:PROTection:TRIPped?
 [:SOURce[]]:VOLTage:RANGe
Note: When [:SOURce[]] or [] is omitted, the parameter of the channel currently selected will be set by
default.