RIGOL DP832A - Manual (Page 69)

Chapter 2 Command System RIGOL
DP800 Programming Guide 2-45
:MONItor Commands
The :MONItor commands are used to set the monitor condition and stop mode of the monitor as well as
enable or disable the monitor (the current channel). For multi-channel models, the instrument can monitor
the output states of multiple channels at the same time. You can send
the :INSTrument:NSELect , :INSTrument[:SELEct] or :INSTrument[:SELect] command to switch the current
channel and set the monitor conditions.
For DP831A/DP832A/DP821A/DP811A, the instrument is installed with the monitor option when it leaves
factory and users can directly use the monitor function. For DP831/DP832/DP821/DP811, the monitor is an
optional function; to use this function, please order the corresponding option and install the option correctly
( :LIC:SET ).
Command List:
 :MONItor:CURRent:CONDition
 :MONItor:CURRent[:VALue]
 :MONItor:POWER:CONDition
 :MONItor:POWER[:VALue]
 :MONItor[:STATe]
 :MONItor:STOPway
 :MONItor:VOLTage:CONDition
 :MONItor:VOLTage[:VALue]