RIGOL DP832A - Manual (Page 79)

Chapter 2 Command System RIGOL
DP800 Programming Guide 2-55
:OUTPut:OCP:CLEAR
Syntax :OUTPut:OCP:CLEAR [CH1|CH2|CH3]
Description Clear the label of the overcurrent protection occurred on the specified channel.
Parameter Name Type Range Default
[CH1|CH2|CH3] Discrete CH1|CH2|CH3 None
Explanation  Before executing the command, make sure that the reason that causes the
OCP on the specified channel is cleared (you can decrease the output current
to be below the OCP value or increase the OCP value to be greater than the
output current).
 When [CH1|CH2|CH3] is omitted, the system clears the label of the OCP
occurred on the current channel.
 You can also send the [:SOURce[]]:CURRent:PROTection:CLEar command
to clear the circuit and label of the OCP occured on the specified channel and
turn on the corresponding channel output.
 You can send the :OUTPut:OCP:ALAR? or :OUTPut:OCP:QUES? command to
query whether OCP occurred on the specified channel.
Example :OUTP:OCP:QUES? CH1 /*Query whether overcurrent protection currently
occurred on CH1 and the query returns YES*/
(Operation: decrease the output current to be below the OCP value or increase the
OCP value to be greater than the output current)
:OUTP:OCP:CLEAR CH1 /*Clear the label of the overcurrent protection occurred
on CH1*/
:OUTP:OCP:QUES? CH1 /*Query whether overcurrent protection occurred on
CH1 and the query returns NO*/
Related
Commands
:OUTPut:OCP:ALAR?
:OUTPut:OCP:QUES?
[:SOURce[]]:CURRent:PROTection:CLEar