RIGOL DP832A - Manual (Page 109)

Chapter 2 Command System RIGOL
DP800 Programming Guide 2-85
[:SOURce[]]:CURRent[:LEVel]:TRIGgered[:AMPLitude]
Syntax [:SOURce[]]:CURRent[:LEVel]:TRIGgered[:AMPLitude] {|MIN|MAX}
[:SOURce[]]:CURRent[:LEVel]:TRIGgered[:AMPLitude]? {|MIN|MAX}
Description Set the trigger current of the specified channel.
Query the trigger current of the specified channel.
Parameter Name Type Range Default
[] Integer 1|2|3 1
Real
0 to the maximum current
of the specified channel
0.1A
Explanation  When [:SOURce[]] or [] is omitted, the system sets the corresponding
parameter of the channel currently selected.
 When the trigger source ( :TRIGger[:SEQuence]:SOURce
or :TRIGger:IN:CHTYpe ) is set to "IMM" (immediate trigger), the system executes
a complete trigger operation (the voltage/current of the specified channel change
to the trigger voltage/current currently set immediately) when executing
the :INITiate or :TRIGger:IN:IMMEdiate command.
 When the trigger source ( :TRIGger[:SEQuence]:SOURce
or :TRIGger:IN:CHTYpe ) is set to "BUS" (bus trigger, namely software trigger),
the system generates a trigger by executing the *TRG command after executing
the :INITiate or :TRIGger:IN:IMMEdiate command to initialize the trigger system.
Then, the power supply executes a trigger operation (the voltage/current of the
specified channel change to the trigger voltage/current currently set) after the
specified delay time (if the delay time is set, :TRIGger[:SEQuence]:DELay ).
 You can also send the :TRIGger:IN:CURRent command to set the trigger current
of the specified channel.
Return
Format
The query returns the trigger current of the specified channel, for example, 1.0000A.
Example :CURR:TRIG 1 /*Set the trigger current of the current channel to 1A*/
:CURR:TRIG? /*Query the trigger current of the current channel and the query
returns 1.0000A*/
Related
Commands
:TRIGger[:SEQuence]:SOURce
:TRIGger:IN:CHTYpe
:INITiate
:TRIGger:IN:IMMEdiate
*TRG
:TRIGger[:SEQuence]:DELay
:TRIGger:IN:CURRent