RIGOL DP832A - Manual (Page 111)

Chapter 2 Command System RIGOL
DP800 Programming Guide 2-87
[:SOURce[]]:CURRent:PROTection[:LEVel]
Syntax [:SOURce[]]:CURRent:PROTection[:LEVel] {|MINimum|MAXimum}
[:SOURce[]]:CURRent:PROTection[:LEVel]? [{MINimum|MAXimum}]
Description Set the overcurrent protection (OCP) value of the specified channel.
Query the overcurrent protection (OCP) value of the specified channel.
Parameter Name Type Range Default
[] Integer 1|2|3 1
Real Refer to Table 2-2
Explanation  When the overcurrent protection function of the specified channel is enabled
( [:SOURce[]]:CURRent:PROTection:STATe ), the output turns off
automatically when the output current exceeds the overcurrent protection
value currently set. You can send the
[:SOURce[]]:CURRent:PROTection:TRIPped? command to query whether
overcurrent protection occurred on the specified channel currently.
 When [:SOURce[]] or [] is omitted, the system sets the
corresponding parameter of the channel currently selected.
 You can also send the :OUTPut:OCP:VALue command to set the OCP value of
the specified channel.
Return Format The query returns the overcurrent protection value of the specified channel, for
example, 5.0000.
Example :CURR:PROT 5 /*Set the OCP value of the current channel to 5A*/
:CURR:PROT? /*Query the OCP value of the current channel and the query
returns 5.0000*/
Related
Commands
[:SOURce[]]:CURRent:PROTection:STATe
[:SOURce[]]:CURRent:PROTection:TRIPped?
:OUTPut:OCP:VALue