RIGOL DP832A - Manual (Page 116)

RIGOL Chapter 2 Command System
2-92 DP800 Programming Guide
[:SOURce[]]:VOLTage[:LEVel]:TRIGgered[:AMPLitude]
Syntax [:SOURce[]]:VOLTage[:LEVel]:TRIGgered[:AMPLitude] {|MIN|MAX}
[:SOURce[]]:VOLTage[:LEVel]:TRIGgered[:AMPLitude? {MIN|MAX}
Description Set the trigger voltage of the specified channel.
Query the trigger voltage of the specified channel.
Parameter Name Type Range Default
[] Integer 1|2|3 1
Real
0 to the maximum voltage of the
specified channel
0V
Explanation  When [:SOURce[]] or [] is omitted, the system sets the
corresponding parameter of the channel currently selected.
 When the trigger source ( :TRIGger[:SEQuence]:SOURce
or :TRIGger:IN:CHTYpe ) is set to "IMM" (immediate trigger), the system
executes a complete trigger operation (the voltage/current of the specified
channel change to the trigger voltage/current currently set immediately) when
executing the :INITiate or :TRIGger:IN:IMMEdiate command.
 When the trigger source ( :TRIGger[:SEQuence]:SOURce
or :TRIGger:IN:CHTYpe ) is set to "BUS" (bus trigger, namely software trigger),
the system generates a trigger by executing the *TRG command after
executing the :INITiate or :TRIGger:IN:IMMEdiate command to initialize the
trigger system. Then, the power supply executes a trigger operation (the
voltage/current of the specified channel change to the trigger voltage/current
currently set) after the specified delay time (if the delay time is
set, :TRIGger[:SEQuence]:DELay ).
 You can also send the :TRIGger:IN:VOLTage command to set the trigger
voltage of the specified channel.
Return Format The query returns the trigger voltage of the specified channel, for example, 1.000V.
Example :VOLT:TRIG 1 /*Set the trigger voltage of the current channel is 1V*/
:VOLT:TRIG? /*Query the trigger voltage of the current channel and the query
returns 1.000V*/
Related
Commands
:TRIGger[:SEQuence]:SOURce
:TRIGger:IN:CHTYpe
:INITiate
:TRIGger:IN:IMMEdiate
*TRG
:TRIGger[:SEQuence]:DELay
:TRIGger:IN:VOLTage