RIGOL DP832A - Manual (Page 157)

Chapter 2 Command System RIGOL
DP800 Programming Guide 2-133
Related
Command
:OUTPut:TIMEr
:TIMEr[:STATe]
Syntax
:TIMEr[:STATe] {ON|OFF}
:TIMEr[:STATe]?
Description Enable or disable the timing output function.
Query the status of the timing output function.
Parameter Name Type Range Default
{ON|OFF} Bool ON|OFF OFF
Explanation  Enabling the timer will change the output state of the channel; make sure that
the change in the output state will not affect the device connected to the
power supply before enabling the timer.
 The timing output is valid only when both the timer and the channel output are
enabled.
 When the timer is enabled, the timer parameters cannot be modified.
 For multi-channel models, you can send
the :INSTrument[:SELEct] , :INSTrument[:SELect] or :INSTrument:NSELect
command to switch the current channel, set the timer parameters of the
channel selected and enable or disable the timer.
 The timer and delayer ( :DELAY[:STATe] ) cannot be enabled at the same time.
 You can also send the :OUTPut:TIMEr:STATe command to turn on or off the
timer output function.
Return Format The query returns ON or OFF.
Example :TIME ON /*Enable the timing output*/
:TIME? /*Query the status of the timing output and the query returns ON*/
Related
Commands
:INSTrument[:SELEct]
:INSTrument[:SELect]
:INSTrument:NSELect
:DELAY[:STATe]
:OUTPut:TIMEr:STATe
:TIMEr:TEMPlet:CONSTruct
Syntax :TIMEr:TEMPlet:CONSTruct
Description Send this command and the instrument will create the timer parameters according
to the templet currently selected and the parameters set.