RIGOL DP832A - Manual (Page 41)

Chapter 2 Command System RIGOL
DP800 Programming Guide 2-17
:DELAY:STOP
Syntax :DELAY:STOP {NONE|V|C|P}[,|MINimum|MAXimum]
:DELAY:STOP? [MINimum|MAXimum]
Description Set the stop condition of the delayer.
Query the stop condition of the delayer.
Parameter Name Type Range Default
{NONE|V|
C|P}
Discrete NONE|V|C|P NONE
Real
0 to the maximum
voltage/current/power of the
current channel
0V/0A/0W
Explanation  The power supply monitors the output voltage, current and power during delay
output. Use this command to set a stop condition and the delay output stops
when state that fulfills this condition is detected.
 "NONE", "V" "C", "P" can set the stop condition to
"None", "Volt", "Curr", "Power"
respectively.
 is used to set the voltage, current or power of the stop condition and
when it is omitted, this command is used to select the stop condition.
Return Format The query returns NONE or "stop condition,value", for example, >V,8.000.
Example :DELAY:STOP >V,8 /*Set the stop condition of the delayer to ">8V"*/
:DELAY:STOP? /*Query the current stop condition of the delayer and the
query returns >V,8.000*/