RIGOL DP832A - Manual (Page 107)

Chapter 2 Command System RIGOL
DP800 Programming Guide 2-83
[:SOURce[]]:CURRent[:LEVel][:IMMediate][:AMPLitude]
Syntax [:SOURce[]]:CURRent[:LEVel][:IMMediate][:AMPLitude]
{|MINimum|MAXimum}
[:SOURce[]]:CURRent[:LEVel][:IMMediate][:AMPLitude]?
[{MINimum|MAXimum}]
Description Set the current of the specified channel.
Query the current of the specified channel.
Parameter Name Type Range Default
[] Integer 1|2|3 1
Real Refer to Table 2-1
Explanation  When [:SOURce[]] or [] is omitted, the command sets the
corresponding parameter of the channel currently selected by default.
 When is selected, the system sets the current of the specified
channel directly; when MINimum or MAXimum is selected, the system sets the
current of the specified channel to the minimum or maximum (refer to Table
2-1) within the current range of this channel (multi-channel models) or the
range currently selected of the channel (single-channel model); when UP or
DOWN is selected, the system increases or reduces the current at the step set
by the [:SOURce[]]:CURRent[:LEVel][:IMMediate]:STEP[:INCRement]
command.
 You can also send the :APPLy command to set the voltage and current of the
specified channel.
Return Format The query returns the current of the specified channel, for example, 1.5000.
Example :CURR 1.5 /*Set the current of the current channel to 1.5A*/
:CURR? /*Query the current setting value of the current channel and the query
returns 1.5000*/
Related
Commands
:APPLy
[:SOURce[]]:CURRent[:LEVel][:IMMediate]:STEP[:INCRement]