RIGOL DP832A - Manual (Page 36)

RIGOL Chapter 2 Command System
2-12 DP800 Programming Guide
:DELAY:CYCLEs
Syntax :DELAY:CYCLEs {N|I}[,]
:DELAY:CYCLEs?
Description Set the number of cycles of the delayer.
Query the number of cycles of the delayer.
Parameter Name Type Range Default
{N|I} Discrete N|I N
Integer 1 to 99999 1
Explanation  The number of cycles refers to the number of times that the instrument
performs delay output according to the preset state. Wherein, I represents
infinite number of cycles; N represents finite number of cycles. The number of
cycles is specified by and when this parameter is omitted, the number
of cycles is set to 1 by default.
 The total number of groups of the delay output = the number of groups × the
number of cycles; wherein, the number of groups is set by the :DELAY:GROUPs
command.
 The power supply will terminate the delayer function when the total number of
groups of delays is finished or when the state that meets the "stop condition"
(the :DELAY:STOP command) is detected. At this point, the state of the power
supply depends on the setting of the :DELAY:ENDState command.
Return Format The query returns I or N,, for example, N,100.
Example :DELAY:CYCLE I /*Set the number of cycles to "Infinite" */
:DELAY:CYCLE N /*Set the number of cycles to 1*/
:DELAY:CYCLE N,100 /*Set the number of cycles to 100*/
:DELAY:CYCLE? /*Query the current number of cycles and the query returns
N,100*/
Related
Commands
:DELAY:GROUPs
:DELAY:STOP
:DELAY:ENDState