Grass Valley M-Series iVDR User Manual v.2.0.10 - Manual (Page 86)

86 M-Series User Manual 20 April 2005
Chapter 3 Product Description
The Calibration Applet window opens.
4. On the Calibration tab, touch Calibration , then follow onscreen instructions to
calibrate the touch panel.
CAUTION: Do not modify any other settings in the Calibration Applet
window. These are factory set for optimal performance.
5. Touch OK in the Calibration Applet window to exit.
6. Close Control Panel.
7. Click the maximize button in the AppCenter title bar and test the touch panel.
Adjusting front panel display brightness
You can adjust front panel display brightness for best display depending on ambient
light conditions. The brightness control is located on the back side of the front panel.
Enabling the VGA monitor output
You can display AppCenter on the VGA monitor output and the optional Front Panel
at the same time. This allows you to monitor iVDR operations on a larger display. The
rear panel VGA monitor connector is disabled at the factory when the optional front
panel is installed. You can enable the VGA output by connecting an external keyboard
and pressing a display mode hot-key sequence. The following table shows the VGA
output hot-key sequences for switching between display modes.
!
Monitor Mode External keyboard hot-key
sequence to use
Front panel only Ctrl + Alt + L
VGA output only Ctrl + Alt + C
Front panel and VGA output
a
a.
Configure screen resolution in Windows for 640x480 for full screen
display.
Ctrl + Shift + C