Setting record channel ntsc pedestal – Grass Valley M-Series iVDR User Manual v.2.0.10 User Manual
Page 108
108
M-Series User Manual
20 April 2005
Chapter 4 Modifying Configuration
3. Select a video input. Your selection takes effect immediately without closing the
Configuration dialog box.
• SDI component — Make this selection to record SDI component video
connected to the record channel’s SDI input. If a warning message is displayed
about SDI not present, verify that and SDI signal is connected. When you select
SDI component video, there are no other configuration options available.
Proceed to
“Configuring the VITC reader” on page 110
.
• Analog composite — Make this selection to record analog composite video
connected to the record channel’s Composite input. If a warning message is
displayed about composite signal not present, verify that and composite signal
is connected. When you select Analog composite additional input settings are
available as explained in the next procedure
Setting record channel NTSC pedestal
1. Make sure NTSC is selected as instructed in the previous procedure
. If NTSC is not selected the pedestal setting is not
available.
2. Select
System
and choose
Configuration
, then select the
Channel
button, select the
R1
or
R2
tab, and open the
Video Input
link. Close other links or use the scroll button
if necessary to locate the link.
3. Locate the statement “Analog composite input settings:”.
4. If you are operating with a standard NTSC input signal with 7.5 IRE setup, then
select the pedestal check box. You must make this selection for both record
channels.
For play channel settings refer to