Grass Valley M-Series iVDR User Manual v.2.0.10 - Manual (Page 209)

20 April 2005 M-Series User Manual 209
Changing the event thumbnail image
Changing the event thumbnail image
By default, an event's thumbnail is set to the thumbnail of its source clip.
To change an event's thumbnail:
1. Select the event in List View.
2. Select the Event button in the toolbar to change to Event View.
3. Monitor video output and use the front panel or onscreen transport controls to
position the clip to the desired video frame.
4. Select the thumbnail to image in Event pane to open the pop-up menu, then select
Set Event Thumbnail .
The event will now be represented by the new thumbnail. If the event is the first
play event in the list, then the list thumbnail is updated to refer to the new event
thumbnail.
NOTE: If the you modify the event marks so that the thumbnail is outside of the
event's media, the thumbnail is automatically changed to correspond to the event's
mark in position.
Adjusting the event audio level
The audio level for each event in the list is adjusted independently.
To adjust the event audio level:
1. With the event loaded in the Event view, select the Meterbar button .
2. Adjust the audio level using the graphical faders or select Unity to return audio to
the last saved level.
3. Select Save to save changes to the event audio level.
NOTE: Changing event audio levels does not affect the source clip. Saved audio
levels are stored and used every time the list is loaded and played. Unsaved changes
are lost when another list is loaded.
4. Select the Meterbar button again to return to List view.