Grass Valley M-Series iVDR User Manual v.2.0.10 - Manual (Page 37)

20 April 2005 M-Series User Manual 37
Setting up the Ethernet network
Setting up the Ethernet network
Refer to the following list of procedures, then perform the ones required to set up the
Ethernet network for your application.
• “Connecting the Ethernet network cabling”
Shows how to connect the iVDR to an Ethernet network using the standard
100BaseT port or the optional 1GBaseT port.
• “100BaseT Configuration: Data and streaming between iVDRs” Contains
instructions for configuring the 100BaseT network connection to provide standard
data network capability and for streaming media transfers between iVDRs.
• “1GBaseT Configuration: Data and streaming between iVDRs” Contains
instructions for configuring the 1GBaseT network connection to provide standard
data network capability and for streaming media transfers between iVDRs.
• “Operating with both 100BT and 1GBT network connections”
Describes how to set up both networks so that you can use the low speed network
for standard data network tasks, and the high speed network for streaming transfers
between iVDRs.
• “100BaseT Configuration: iVDR and Profile XP streaming” . Follow these
instructions if you use the network for streaming media transfers to non-M-Series
devices such as the Profile XP Media Platform.
Connecting the Ethernet network cabling
Connect as illustrated. The high-speed (1 Gb) connection is available only if you have
the optional card installed.
R2 CH1
P2 CH2
OUT
IN
H2 P2 LTC P2 CH1
R2 CH2 R2 LTC 2
Analog
Audio
Pu sh Pu sh Pu sh
Cmpst
REF
P2 OUT L R
2
Loop Thru
GPIO Audio MON Out !
10/100BT Network
1000BT Network
(with optional card only)
10Bt
100Bt
1000Bt
PORT 3
PORT 4
RS422
PORT 1
PORT 2
RS422
SCSI VGA
FRONT
PANEL