Monitoring remote control communications, Monitoring remote control, See “monitoring remote control – Grass Valley M-Series iVDR User Manual v.2.0.10 User Manual
Page 297
20 April 2005
M-Series User Manual
297
Monitoring remote control communications
Monitoring remote control communications
The Protocol Monitor button
is displayed in the AppCenter StatusBar when a
protocol application is running on an iVDR channel. The button flashes when any
channel is receiving remote control messages. Clicking the button opens the Protocol
Monitor dialog box which you can use to determine which channels are receiving
messages.
NOTE: The Protocol Monitor dialog will not open until a controller is connected
and at least one command set is sent.
To open the Protocol Monitor dialog box:
• Click the Protocol Monitor button
in the AppCenter StatusBar.
The dialog box displays the channel number and protocol being used, along with
the port number and control mode (Local or Protocol only). The green status LED
indicates the port is receiving protocol commands.