Grass Valley M-Series iVDR User Manual v.2.0.10 - Manual (Page 40)

40 M-Series User Manual 20 April 2005
Chapter 1 Installing the M-Series iVDR
4. Select Add , to open the Add Host dialog box, then do the following:
a. Select the “Enter host name:” text entry control, then enter the computer name
of a peer iVDR.
Make sure to enter the exact computer name. Any differences will result in being
unable to connect to the iVDR.
b. If you are using remote protocols to perform video network transfers, you must
use the following steps to add a unique Controller ID for each host, otherwise,
you can ignore this step and proceed to step c.
- Select the “Enter controller ID:” text entry control.
- Enter the controller ID of the iVDR, then select OK .
Make sure to enter a number between 1 and 255 that is unique to the iVDR.
c. Select OK in the Add Host dialog box.
5. Repeat step 4 for the remaining iVDRs.