Grass Valley M-Series iVDR User Manual v.2.0.10 - Manual (Page 206)

206 M-Series User Manual 20 April 2005
Chapter 8 Working With Playlists
Using the Event In/Out buttons
To move clip marks:
1. Use the transport controls to locate the desired frame.
NOTE: If the List view is playing a list, you cannot monitor video and audio of an
event when you switch to the Event view. The channel resources— video and audio
outputs, are being used by the List view application. However, you can still edit an
event in Event view by using the event in/out timecode controls to enter timecodes
values.
2. In Event view, select Event In to set mark-in point, or Event Out to
set mark-out point.
3. Do one of the following:
• For an existing event, select Accept to propagate the change to the event in the
list.
• For a new event, select Insert to add the event to the list.
Using the timecode entry controls
1. In Event view, select the Event-In or Event-Out timecode control to
open the timecode entry dialog box.
2. Enter a timecode value using the onscreen keypad, or an external keyboard, then
select OK or Enter .
Alternatively: Use the current position scrub bar in the timecode entry
dialog box to locate the desired frame, then select OK .