Grass Valley M-Series iVDR User Manual v.2.0.10 - Manual (Page 182)

182 M-Series User Manual 20 April 2005
Chapter 7 Playing and Editing
Selecting E to E mode
When E to E is selected, the play channel video and audio outputs are switched to the
corresponding record channel inputs when the play channel is in stop mode or when
no clip is loaded. The following table describes play channel operation depending the
E to E selection.
E to E considerations
If E to E mode is enabled, you can connect an external reference signal which is
synchronous to the video input. This will eliminate artifacts on the play channel
output (periodic vertical shift) due to routing an asynchronous signal through the
iVDR. However, this is not required for recording, the iVDR can record asynchronous
signals.
To enable/disable E to E mode:
• In Play view, select the context menu button , then select the E to E menu item.
E to E Setting Play channel mode Play channel output
Disabled Play, FF, Rewind
Stop
Eject Show clip
Show clip
Show black
Enabled Play, FF, Rewind
Stop
Eject Show clip
Show input
a.
Show input a.
a.
Output is black if no video input is connected.