Grass Valley M-Series iVDR User Manual v.2.0.10 - Manual (Page 123)

20 April 2005 M-Series User Manual 123
Configuring GPI outputs
2. Select the Output tab.
The GPI Output settings open.
3. Select a GPI output signal (1 - 12). Use the scroll control as necessary.
4. Select the channel you want to trigger the GPI output.
5. Select the Name text entry control and enter a name for the action.
6. Set the active signal (high/low) and pulse width (60/100 fields) required.
This is determined by the external equipment connected to the GPI output.
7. Repeat step 3 through step 6 for the remaining GPI outputs.
8. Select OK on the Configuration dialog, or leave the Configuration Manager open
to configure other iVDR settings.
Also refer to these related topics:
• “GPI I/O specifications” on page 305
• “GPI I/O connector pinouts” on page 316
• “Connecting GPI” on page 54
• “Using GPI output triggers in playlists” on page 200