Grass Valley M-Series iVDR User Manual v.2.0.10 - Manual (Page 281)

20 April 2005 M-Series User Manual 281
Starting a remote control protocol application
Starting a remote control protocol application
The protocol applications require a channel on which to run. If the channel is currently
being used by another application, you can use the following steps to select the
protocol application. Selecting the protocol application causes the current channel
application to exit when the protocol application is started.
To start a protocol application on a channel:
1. In the toolbar, select Split Screen .
2. In the toolbar, select Monitor .
3. In the Monitor pane, select the control application drop-down list for a
channel, then choose a protocol application.
Player protocol applications are available on play channels. Recorder protocol
applications are available on record channels.
The protocol application starts on the channel.
4. Proceed to “Selecting the control port and control mode” .
Select Monitor
Choose from the
Control Application
in the drop-down list
2
3
Select Split Screen 1