Grass Valley M-Series iVDR User Manual v.2.0.10 - Manual (Page 314)

314 M-Series User Manual 20 April 2005
Appendix B Rack-mounting and Connector Pin-outs
Adjusting rack-mount brackets
The four-position adjustable rack-mount brackets allows the iVDR to accommodate
different rack depth limitations. The rack-mount bracket is shipped in the forward
position allowing the iVDR front panel to fit flush with the front of the rack.
To reposition the rack-mount brackets:
1. Slide the chassis out approximately 10 inches, and remove the three mounting
screws using Torx tool with a T15 tip.
2. Move the bracket toward the rear to accommodate rack depth, then align the
chassis mounting holes with the nearest bracket mounting holes.
3. Replace the screws.
1
Move bracket toward
rear, and align chassis
mounting holes with the
nearest bracket mounting
holes. 2
Remove
screws
Replace
screws 3