Grass Valley M-Series iVDR User Manual v.2.0.10 - Manual (Page 48)

48 M-Series User Manual 20 April 2005
Chapter 1 Installing the M-Series iVDR
Make 100BaseT network connections
Make 100BaseT network connections for both the iVDR and the Profile XP system
as shown in the following illustration. Refer to
“Connecting the Ethernet network
cabling” on page 37 to locate iVDR rear panel network connectors. Refer to the
Profile XP System Guide to locate network connections on the Profile XP rear panel.
Configure the iVDR static IP address
This procedure guides you to the relevant steps to configure a static IP address on the
iVDR. It is assumed that you understand Ethernet networks in general and that you
can apply that understanding to configure this network setting using standard
Windows tools. If you need help with these procedures, contact your network
administrator.
To set up the static IP address on the 100BaseT adapter:
1. If you normally operate your M-Series iVDR using the optional Front Panel
touch-screen, you should connect keyboard and mouse before proceeding. You
will likely find it easier to configure your network using a keyboard and mouse
rather than the touch-screen. Refer to
“Keyboard, mouse, and VGA monitor
connections” on page 26 . You may need to restart Windows to make the mouse and
keyboard operational.
2. Shut down AppCenter as follows:
a. In the AppCenter toolbar, select System , then choose Shutdown in the pop-up
menu.
The Shutdown dialog box appears.
b. Using the drop-down list, choose Exit to Windows , then select OK .
AppCenter shuts down and the Windows desktop appears.
iVDR-1
ProfileXP-1
Ethernet
Switch
VAR
JOG SHTL
R1
P2
P1
R2
Refer to the Profile XP System
Guide to make cable connections.
100BaseT
Network
iVDR-2
VAR
JOG SHTL
R1
P2
P1
R2