Grass Valley M-Series iVDR User Manual v.2.0.10 - Manual (Page 201)

20 April 2005 M-Series User Manual 201
Using GPI output triggers in playlists
Event GPI properties page
3. Select Trigger GPI, then use the drop-down list to select a GPI output.
NOTE: If no GPI outputs are listed, use Configuration Manager to assign GPI
outputs to the current channel, then return to this step.
See “Configuring GPI
outputs” on page 122 .
4. Select the trigger action for the GPI output.
5. Select OK to save settings.
Action Trigger point
Start of event or section First frame of event or section
End of event or section Last frame of event or section
Start of event or section plus Start of event or section plus the time entered using
the text entry control. Offset should not exceed the
event or section total length.
a
a.
If the offset time entered exceeds the event or section length, a warning message is
displayed.
End of event or section minus End of event or section minus the time entered
using the text entry control. Offset should not
exceed the event or section total length.
a.