Grass Valley M-Series iVDR User Manual v.2.0.10 - Manual (Page 205)

20 April 2005 M-Series User Manual 205
Modifying events in the list
Modifying events in the list
Modifying events includes the following tasks:
• “Moving Event-In and Event-out marks” on page 205
• “Clearing Event-In/Event-out marks” on page 207
• “Pausing at the end of an event” on page 208
• “Changing the event thumbnail image” on page 209
• “Adjusting the event audio level” on page 209
• “Moving events in the list” on page 210
• “Renaming an event” on page 211
• “Viewing play event properties” on page 210
About editing events while playing a list
You cannot use the Event view while playlist is playing. You must stop play back,
then open Event view to edit an event.
Moving Event-In and Event-out marks
Every event has a event-in point and an event-out point which refer to the first and last
frames displayed when the event plays. When first created, event marks are set to the
mark-in and mark-out of the source clip. You can edit the event marks in order to
reference only the desired media. Event marks can be cleared to reset them to the
marks specified in the source clip. (See
“Clearing Event-In/Event-out marks” on
page 207 .)
The following restrictions apply when editing event marks:
• Event-in must precede the Event-out
• Event marks cannot be set outside the recorded media of the source clip.
NOTE: If more media exists outside the current mark, a <<< or >>> symbol are
displayed beneath the current event mark timecode.
To move event marks, view the event in Event view, then use one of the following
methods to move clip marks.
• “Using the Event In/Out buttons” on page 206
• “Using the timecode entry controls” on page 206
• “Using the event length control” on page 207