beautypg.com

N in, Figure 41 – H3C Technologies H3C WX3000E Series Wireless Switches User Manual

Page 98

background image

84

Specify the account name as dot1x and configure the password

Select the access service Dot1x auth

Configure other parameters accordingly and click OK to finish the operation

Figure 41 Adding an access user account

2.

Configure the RADIUS server (when the server runs on IMC PLAT 5.0)

NOTE:

This section assumes that the RADIUS server runs on IMC PLAT 5.0 (E0101) and IMC UAM 5.0 (E0101).

# Add an access device.
Log in to IMC, click the Service tab, and select User Access Manager > Access Device Management >

Access Device from the navigation tree. Then, click Add to configure an access device as follows:

Set the shared key for authentication and accounting to expert

Set the ports for authentication and accounting to 1812 and 1813 respectively

Select LAN Access Service as the service type

Select H3C(General) as the access device type

Select the AC from the device list or manually add the AC with the IP address 10.1.1.2

Leave the default settings for other parameters and click OK to finish the configuration.

NOTE:

The IP address of the access device specified here must be the same as the source IP address of the RADIUS
packets sent from the AC, which is chosen in this order:

The IP address specified with the nas-ip command on the device

The IP address specified with the radius nas-ip command on the device

The IP address of the outbound interface (the default)