H3C Technologies H3C WX3000E Series Wireless Switches User Manual
Page 88
74
Select Portal Service Management > IP Group from the navigation tree to enter the portal IP address
group configuration page. Then, click Add and perform the following configurations as shown in
.
•
Input the name Portal_user
•
Set the start IP address to 192.168.1.1 and the end IP address to 192.168.1.255. The IP address of the
client must be within this IP address group.
•
Select to not enable NAT
•
Click OK to finish the operation.
Figure 28 Adding an IP address group
# Add a portal device.
Select Portal Service Management > Device from the navigation tree to enter the portal device
configuration page. Then, click Add and perform the following configurations as shown in
•
Type the device name NAS.
•
Type the IP address of the access interface on the AC, which is 192.168.1.70.
•
Type the key, which is portal, the same as that configured on the AC.
•
Set whether to enable IP address reallocation. Because direct portal authentication is used in this
example, select No from the Reallocate IP drop-down list.
•
Click OK to finish the operation.
- H3C WX5500E Series Access Controllers H3C WX3500E Series Access Controllers H3C WX2500E Series Access Controllers H3C WX6000 Series Access Controllers H3C WX5000 Series Access Controllers H3C LSWM1WCM10 Access Controller Module H3C LSUM3WCMD0 Access Controller Module H3C LSUM1WCME0 Access Controller Module H3C LSWM1WCM20 Access Controller Module H3C LSQM1WCMB0 Access Controller Module H3C LSRM1WCM2A1 Access Controller Module H3C LSBM1WCM2A0 Access Controller Module H3C WA3600 Series Access Points H3C WA2600 Series WLAN Access Points H3C S10500 Series Switches H3C S5800 Series Switches H3C S5820X Series Switches H3C S12500 Series Switches H3C S9500E Series Switches H3C MSR 5600 H3C MSR 50 H3C MSR 3600 H3C MSR 30 H3C MSR 2600 H3C MSR 20-2X[40] H3C MSR 20-1X H3C MSR 930 H3C MSR 900 H3C SR8800 H3C SR6600-X H3C SR6600 H3C SecPath F5020 H3C SecPath F5040 H3C VMSG VFW1000