beautypg.com

Solution, Failing to establish an ipsec tunnel, Symptom – H3C Technologies H3C WX3000E Series Wireless Switches User Manual

Page 391: Analysis

background image

377

Or

drop message from A.B.C.D due to notification type NO_PROPOSAL_CHOSEN

The two parties in the negotiation have no matched proposals.

Solution

For the negotiation in phase 1, look up the IKE proposals for a match. For the negotiation in phase 2,

check whether the parameters of the IPsec policies applied on the interfaces are matched, and whether
the referred IPsec proposals have a match in protocol, encryption and authentication algorithms.

Failing to establish an IPsec tunnel

Symptom

The expected IPsec tunnel cannot be established.

Analysis

Sometimes this may happen that an IPsec tunnel cannot be established or there is no way to

communicate in the presence of an IPsec tunnel in an unstable network. According to examination results,

however, ACLs of both parties are configured correctly, and proposals are also matched.
In this case, the problem is usually caused by the reboot of one router after the IPsec tunnel is established.

Solution

Use the display ike sa command to check whether both parties have established an SA in phase 1.

Use the display ipsec sa policy command to check whether the IPsec policy on the interface has
established IPsec SA.

If the two commands show that one party has an SA but the other does not, use the reset ipsec sa
command to clear the IPsec SA that has no corresponding SA, use the reset ike sa command to

clear the IKE SA that has no corresponding IKE SA, and trigger SA re-negotiation.