H3C Technologies H3C WX3000E Series Wireless Switches - Manual (Page 324)

310
Step Command Remarks
2. Configure the SFTP
connection idle timeout
period.
sftp server idle-timeout
time-out-value Optional.
10 minutes by default.
Configuring the access controller an SFTP client
Specifying a source IP address or interface for the SFTP client
You can configure a client to use only a specified source IP address or interface to access the SFTP server,
enhancing the service manageability.
To specify a source IP address or interface for the SFTP client:
Step Command Remarks
1. Enter system view. system-view N/A
2. Specify a source IP address or
interface for the SFTP client.
• For the SFTP client:
sftp client source { ip ip-address
| interface interface-type
interface-number }
• For the SFTP client:
sftp client ipv6 source { ipv6
ipv6-address | interface
interface-type
interface-number }
Use either command.
By default, an SFTP client uses the
IP address of the interface
specified by the route of the access
controller to access the SFTP
server.
Establishing a connection to the SFTP server
This configuration task will enable the SFTP client to establish a connection to the remote SFTP server and
enter SFTP client view.
To enable the SFTP client: