H3C Technologies H3C WX3000E Series Wireless Switches - Manual (Page 179)

165
Step Command Remarks
2. Set the maximum number of
online portal users.
portal max-user max-number
The default maximum number of
online portal users allowed
depends on the device model. For
more information, see About the
WX Series Access Controllers
Command References.
Specifying an authentication domain for portal users
After you specify an authentication domain for portal users on an interface, the device uses the
authentication domain for authentication, authorization, and accounting (AAA) of all portal users on the
interface, ignoring the domain names carried in the usernames. This allows you to specify different
authentication domains for different interfaces as needed.
To specify an authentication domain for portal users on an interface:
Step Command Remarks
1. Enter system view. system-view N/A
2. Enter interface view.
interface interface-type
interface-number
N/A
3. Specify an authentication
domain for portal users on the
interface.
portal domain domain-name
By default, no authentication
domain is specified for portal
users.
NOTE:
The device selects the authentication domain for a portal user on an interface in this order: the
authentication domain specified for the interface, the authentication domain carried in the username, and
the system default authentication domain. For information about the default authentication domain, see
"Configuring AAA."
Configuring Layer 3 portal authentication to support web proxy
By default, proxied HTTP requests do not trigger Layer 3 portal authentication but are silently dropped.
To allow such HTTP requests to trigger portal authentication, configure the port numbers of the web proxy
servers on the access device.
Configuration prerequisites
Different clients may have different web proxy configurations. For these clients to trigger portal
authentication, you must satisfy the following prerequisites: