H3C Technologies H3C WX3000E Series Wireless Switches User Manual
Page 82
68
NOTE:
The IP address of the access device specified above must be the same as the source IP address of the
RADIUS packets sent from the device, which is the IP address of the outbound interface (the default), or the
IP address specified with the nas-ip or radius nas-ip command.
Figure 19 Adding an access device
# Add a charging plan.
Select the Service tab, and select Charging Service > Charging Plans from the navigation tree to enter the
charging plan configuration page. Then, click Add to enter the Add Charging Plan page and perform the
following configurations as shown in
:
•
Add a plan named UserAcct
•
Select Flat rate as the charging template
•
In the Basic Plan Settings field, configure the fixed fee as 120 dollars per month
•
In the Service Usage Limit field, set the Usage Threshold to 120 hours, allowing the user to access
the Internet for up to 120 hours per month
•
Adopt the default settings for other parameters and click OK to finish the operation.
- H3C WX5500E Series Access Controllers H3C WX3500E Series Access Controllers H3C WX2500E Series Access Controllers H3C WX6000 Series Access Controllers H3C WX5000 Series Access Controllers H3C LSWM1WCM10 Access Controller Module H3C LSUM3WCMD0 Access Controller Module H3C LSUM1WCME0 Access Controller Module H3C LSWM1WCM20 Access Controller Module H3C LSQM1WCMB0 Access Controller Module H3C LSRM1WCM2A1 Access Controller Module H3C LSBM1WCM2A0 Access Controller Module H3C WA3600 Series Access Points H3C WA2600 Series WLAN Access Points H3C S10500 Series Switches H3C S5800 Series Switches H3C S5820X Series Switches H3C S12500 Series Switches H3C S9500E Series Switches H3C MSR 5600 H3C MSR 50 H3C MSR 3600 H3C MSR 30 H3C MSR 2600 H3C MSR 20-2X[40] H3C MSR 20-1X H3C MSR 930 H3C MSR 900 H3C SR8800 H3C SR6600-X H3C SR6600 H3C SecPath F5020 H3C SecPath F5040 H3C VMSG VFW1000