beautypg.com

Igure, Tdm vcc hdlc, Hdlc e – Verilink XEL XSP-100 SHARK IAP (9SA-USRS-9.0R1.02) Product Manual User Manual

Page 97: Ncapsulation, Tdm channel 1 setup

background image

Chapter 5: Graphical User Interface (GUI/WEB) Configuration Pages

SHARK™ IAD User's Guide

XEL P/N & Release: 9SA-USRS-9.0R1.02

Chapter 5-43

Protocol
Compression--
on/off

Specifies whether you want the SHARK™ IAD to compress the PPP
Protocol field when it transmits datagrams over the PPP link. By
default, protocol field compression is turned on.

Address
Compression--
on/off

Specifies whether you want the SHARK™ IAD to compress the HDLC
Address and Control fields when it transmits datagrams over the PPP
link. By default, address field compression is turned on.

LCP Echo
Requests

Specifies whether you want your SHARK™ IAD to send LCP echo
requests. By default, LCP echoing is turned on. You should turn off
LCP echoing if you do not want the SHARK™ IAD to drop a PPP link
to a non-responsive peer.

Restart timer

Specifies the number of seconds the SHARK™ IAD should wait
before re-transmitting a configuration or termination request. The
integer argument can be any number between 1 and 30. The default
value for the integer argument is 3 seconds. You can reduce the restart
timer value if your link is relatively fast (28,800 bps or greater).
Conversely, you should increase the restart timer value for slow links.

HDLC Channel Select

Page

If you have selected HDLC as encapsulation for a particular TDMs VCC, the
HDLC channel enable page will appear once you click on the save button of the
TDM Channel

configuration page. Figure 39 shows the Channel setup page for

HDLC encapsulation. Enable the VCC by clicking on the on button. Then click
on the save button and you will be returned to the TDM Configuration selection
screen on page 5-37.

Save

TDM Channel 1 Setup

Enable or disable the HDLC circuit on this TDM

Channel 1 Setup

VCC 1

on

off

Figure 39:

TDM VCC HDLC enable page (HDLC Encapsulation)

IP Configuration Page The TDM configurator brings up the IP Configuration page once the save button

is pressed. This page defines the IP parameters as shown in Figure 40.