Verilink XEL XSP-100 SHARK IAP (9SA-USRS-9.0R1.02) Product Manual - Manual (Page 146)

Chapter 6: Using the Command Line Interface (CLI)
Chapter 6-30 XEL P/N & Release 9SA-USRS-9.0R1.02 SHARK™ IAD User’s Guide
ROUTER --- Configure router module parameters
TIMING --- Configure system timing parameters
VOICE-SYS --- Configure system voice parameters
LAN-1 --- Configure LAN module parameters
LAN-2 --- Configure LAN module parameters
WAN-1 --- Configure WAN module parameters
WAN-2 --- Configure WAN module parameters
XC2T --- Configure WAN module parameters
XCON-IF --- Configure cross-connect module parameters
trunk --- Configure trunk processing parameters
VOICE-1 --- Configure voice module parameters
VOICE-2 --- Configure voice module parameters
VOICE-3 --- Configure voice module parameters
(top)>>
This is the resulting display when a "?" is entered at the ROUTER configurator's
top node:
(top)>>ROUTER
(ROUTER)>> ?
(ROUTER)>> ?
ROUTER --- Configure router module parameters
system --- Configure router system parameters
craft-setup --- Configure router Craft port parameters
tdm-setup --- Configure router TDM parameters
fdl-setup --- Configure router fdl interface
ip --- Configure router IP parameters
ppp-setup --- Configure router PPP parameters
snmp --- Configure router snmp parameters
bridge --- Configure router bridging parameters
dns --- Configure router DNS parameters
dhcp --- Configure router DHCP parameters
pinhole --- Configure router pinhole parameters
servers --- Configure router server parameters
(ROUTER)>>
M
ODULE
D
ESIGNATIONS AND
K
EYWORDS
T
REE
Click on the desired subject. This tree only shows 2 levels deep. See this
chapter's table of contents to view the complete tree.
Configuration Command Keywords Page
• TIMING 6-31
– Mode 6-31
– Timing source 6-32
• VOICE-SYS 6-32
– Voice Mode 6-31
– E&M Loop/Ground Select 6-33
– E&M Ringback 6-33
– E&M Forward Disconnect 6-33
• Router 6-33
– System 6-33
– Craft setup 6-35
– TDM 6-35