Verilink XEL XSP-100 SHARK IAP (9SA-USRS-9.0R1.02) Product Manual - Manual (Page 148)

Chapter 6: Using the Command Line Interface (CLI)
Chapter 6-32 XEL P/N & Release 9SA-USRS-9.0R1.02 SHARK™ IAD User’s Guide
available at this time.
TIMING
-
SOURCE
XCON MODULE timing-source <source>
where source [ internal | wan1 | wan2 ]:
XC2T MODULE timing-source <source>
where source [ internal | t1-1 | t1-2 | wan1 | wan2 ]:
Table 3: Timing Sources Descriptions
Timing source Results
internal All outbound T1 traffic is synchronized to the timing source
that is derived from the SHARK™ IAD’s internal clock
source.
wan1 All outbound T1 traffic is synchronized to the timing source
that is derived from the WAN 1 network timing.
wan2 All outbound T1 traffic is synchronized to the timing source
that is derived from the WAN 2 network timing.
t1-1 All outbound T1 traffic is synchronized to the timing source
that is derived from the t1-1 network timing.
t1-2 All outbound T1 traffic is synchronized to the timing source
that is derived from the t1 2 network timing.
CONFIGURING
THE VOICE
SYSTEM
PARAMETERS Use the VOICE-SYS node to configure the voice system features. Go to the
VOICE-SYS node by entering VOICE-SYS at the configurator's top prompt as
shown:
Shark01010100003A> CONFIG
(top)>> VOICE-SYS
(VOICE-SYS)>>
(VOICE-SYS)>> set
VOICE-SYS
voice-mode (CPE) [ CPE | Network ]:
e&m-loop-ground-select (loop) [ loop | ground ]:
e&m-ringback (enable) [ enable | disable ]:
e&m-forward-disconnect (rev-batt) [ rev-batt | tip-open ]:
(VOICE-SYS)>>
VOICE
-
MODE
voice-mode
where mode [ CPE | Network ]:
The Voice mode command controls whether the SHARK™ IAD is in a Central
Office (network environment) or a Customer Premise Equipment environment
(CPE). Only a user who has logged in using the system administrator password
can change this mode. The SHARK™ IAD is factory shipped in the CPE Mode.
N
OTE ON
N
ETWORK OR
CPE V
OICE MODE
To comply with specific FCC requirements the functionality of the Voice
modules has been separated into network and CPE modes.
Do not operate the SHARK™ IAD in the Network Voice mode while it is
installed as CPE equipment at a customer's premise.
Doing such is a violation of your SHARK™ IAD's FCC licensing.