Verilink XEL XSP-100 SHARK IAP (9SA-USRS-9.0R1.02) Product Manual - Manual (Page 109)

Chapter 5: Graphical User Interface (GUI/WEB) Configuration Pages
SHARK™ IAD User's Guide XEL P/N & Release: 9SA-USRS-9.0R1.02 Chapter 5-55
will not load of any of the new configuration.
If there is an error, go the associated configuration page and correct it. Then
reselect the Review Router / Restart page. Review your changes and restart the
router again. Continue this process until the router reboots cleanly without any
errors. Figure 52 shows the results of a successful validation and load of a valid
router configuration.
In any case, the SHARK™ IAD will not automatically clear and continue past
the router restart (coldstart) report page. You must select a button from the side
bar to continue.
Once the router has been restarted, return to the home page by clicking on the
home
button of the side bar. Continue to configure your SHARK™ IAD by
configuring your SHARK™ IAD's T1 transport. This is done through the T1
Configuration
pages discussed next.
XEL SH
ARK
d
evi
ce
ID:xel
sh
ark1
00
00
11
Home
Help
Status/
Alarms
Maintenance
XEL SHARK
device ID:xel shark1000011
XEL Communications Inc, 17101 East Ohio Drive, Aurora Co 80017
XSP 1OO Shark
TM
coldstart router
Cold/Clear starting Router scheduled in 2 seconds
Goodbye.
Figure 52: Clean restart of router