Verilink XEL XSP-100 SHARK IAP (9SA-USRS-9.0R1.02) Product Manual - Manual (Page 37)

Chapter 3: Cable Guide
SHARK™ IAD User's Guide XEL P/N & Release: 9SA-USRS-9.0R1.02 Chapter 3-7
M
ODEL
: 9SA-1230- X05/X10/X25 T1 X
OVER
C
ABLES
Description: RJ-48 (M) to RJ-48 (M) Cross over cable for T1
Length: 9SA-1230-X05
9SA-1230-X10
9SA-1230-X25 5 feet
10 feet
25 feet
Pair Twists: RJ48 1-2, 4-5
Function: The 9SA-1230-Xxx series of cables are used to connect terminal interface
devices to the T1 interface modules of the SHARK™ IAD where a T1 cross over
is necessary.
NOTES Figure 4 shows the installation FCC required EMI filters.
RJ48(M)
RJ48(M)
Figure 3: Model 9SA-1230-Xxx T1 Xover Series cable diagram
CAT 5 cable transporting
T1 signals. Loop cable
through the filter as shown. T1 connector that
connects to T1 module
9SA-T100-000
XEL part number 180-A2003-01 supplied with module 9SA-T100-000
2"
FCC requirements are that the EMI filter be
installed by the customer approximately 2" from
the end of the T1 input cable as shown.
Figure 4: CAT 5 cable used for T1 transmission EMI filter installation
Table 2: Model 9SA-1230-Xxx T1 Xover Series cable Pin Assignments
Signal
Name
RJ-48(M)
Pin #
Twisted
Pair
RJ-48(M)
Pin #
R 1 4
T 2 5
R1 4 1
T1 5 2
3 N/C
6 N/C
DRAIN 7 7
DRAIN 8 8