Verilink XEL XSP-100 SHARK IAP (9SA-USRS-9.0R1.02) Product Manual - Manual (Page 103)

Chapter 5: Graphical User Interface (GUI/WEB) Configuration Pages
SHARK™ IAD User's Guide XEL P/N & Release: 9SA-USRS-9.0R1.02 Chapter 5-49
Save
DHCP Configuration
Mode : off server relay-agent
Start Address
End Address
Lease Time
Server Address
Figure 46: DHCP configuration page
Table 17: DHCP parameter definitions
Parameter Description
Mode:
Start Address:
END Address:
Lease Time:
Server Address:
Sets the DHCP mode to Off, Server, or Relay-agent.
– OFF: The SHARK™ IAD does not assign any addresses.
All LAN side workstations must have a static address
assigned to them.
– Server: The SHARK™ IAD operates as a typical DHCP
server handing out LAN addresses as workstations are
attached to the network and reassigning addresses to
workstations whose lease time has run out.
– Relay-Agent: The SHARK™ IAD acts as a "pass-
through" entity. In this mode, any address assigned by an
upstream DHCP server that is located on the WAN
network will be passed through to a workstation on the
LAN side network. The SHARK™ IAD does not assign
any addresses in this mode; consequently workstations
must get their addresses from the upstream WAN side
DHCP server.
The beginning IP address for the range of IP addresses that
will be assigned.
The ending IP address for the range of IP addresses that will
be assigned.
The length that each dynamic address can be used without
being reissued. Format is dd:hh:mm:ss
(day:hour:minute:second) Default lease time is one hour.
The address of the remote DHCP server that will act as the
server to hand out addresses to the workstations on the LAN
side of this unit.
Once the save button is pressed the SHARK™ IAD returns to the IP/Routing
configuration
menu.