Ip worksheets, Fast ethernet port information, Able – Verilink XEL XSP-100 SHARK IAP (9SA-USRS-9.0R1.02) Product Manual User Manual
Page 82: Outer, Ddressing table, Orksheet

Chapter 5: Graphical User Interface (GUI/WEB) Configuration Pages
Chapter 5-28
XEL P/N & Release: 9SA-USRS-9.0R1.02
SHARK™ IAD User's Guide
IP worksheets
Table 7:
Router Addressing table Worksheet
IP Address:
From the ISP provider for internet access
Net Mask:
Subnet mask in use for the network connected to
the WAN port; typically:
255.255.255.0
Default Gateway:
IP address of the host to which the SHARK™
IAD should send network traffic when it can’t
find the destination host.
Domain Name:
The name of the DNS domain you access most
frequently.
Primary Nameserver Address:
The IP address of the primary DNS nameserver
for your network.
Secondary Nameserver address:
The IP address of the secondary DNS
nameserver for your network.
Fast Ethernet Port
Information
When you are using the 10/100 BaseT Fast Ethernet port (referred to as the Fether
port) you must define:
•
IP address of the Fether port. Such as: 192.168.1.254
This address is usually a private address in your existing LAN subnet range.
•
Broadcast address for the Fether port. Such as: 192.168.1.255
•
Netmask for the Fether port. Such as: 255.255.255.0
This address is usually a private address in your existing LAN subnet range.
You may record your Fether port addresses below:
Fether port private IP address:
.
.
.
Fether port Broadcast address:
.
.
.
Fether port Netmask:
.
.
.