Note: wan loopback connections, Router connections, Loopback connections – Verilink XEL XSP-100 SHARK IAP (9SA-USRS-9.0R1.02) Product Manual User Manual
Page 74: Outer connections, Igure, Xc2t wan, T1 c, Ross, Onnect, Cross connect wan-1 configuration

Chapter 5: Graphical User Interface (GUI/WEB) Configuration Pages
Chapter 5-20
XEL P/N & Release: 9SA-USRS-9.0R1.02
SHARK™ IAD User's Guide
Figure 17:
XC2T WAN and T1 Cross Connect Page
N
OTE
:
WAN
LOOPBACK
CONNECTIONS
As is shown in Figure 15 and Figure 17, this configuration page will not allow
the user to loop back a WAN channel onto itself or to another channel on the
same module. Loopback functions are provided in the
home/maintenance/diagnostics/loopbacks page. See the Diagnostics chapters of
this manual for a description on the SHARK™ IAD's test features.
R
OUTER
CONNECTIONS
Only one group of contiguous channels may be cross connected from each WAN
port of the XCON module or from each WAN or T1 port of the XC2T module to
the Router. In addition, WAN-1 connections must use different router channels
than connections on WAN-2. The Router’s TDM must be configured to use the
same DS0s as the cross connect destination parameter. See the TDM setup
section Configure TDM Channels on page 5-35.
Cross Connect WAN-1 Configuration
Source
Time-Slot
Destination
Time-Slot
Destination
Time-Slot
Destination
Module
Source
Time-Slot
Time Slot 1
Time Slot 2
Time Slot 3
Time Slot 4
Time Slot 5
Time Slot 6
Time Slot 7
Time Slot 8
Time Slot 9
Time Slot 10
Time Slot 11
Time Slot 12
Time Slot 13
Time Slot 14
Time Slot 15
Time Slot 16
Time Slot 17
Time Slot 18
Time Slot 19
Time Slot 20
Time Slot 21
Time Slot 22
Time Slot 23
Time Slot 24
Destination
Module
View Cross Connect T1-1 Configuration
View WAN-1 Trunk Processing Configuration
1
2
3
4
5
6
router
router
router
router
router
router
none
none
lan1
lan1
lan1
lan1
voice1
voice1
voice1
voice1
voice1
voice1
voice1
voice1
voice2
voice2
voice2
voice2
4
4
6
5
3
3
2
2
1
1
7
8
1
2
3
4
Save
Clear All
View Cross Connect T1-2 Configuration
View Cross Connect WAN-2 Configuration