beautypg.com

Executing a voice module test, Diagnostics: ping utility, Executing a voice module test -14 – Verilink XEL XSP-100 SHARK IAP (9SA-USRS-9.0R1.02) Product Manual User Manual

Page 198: Iagnostics, Tility, Igure, Isplay output of, Oice, Odule, Ests

background image

Chapter 8- Maintenance/Diagnostics/Monitoring

Chapter 8-14

XEL P/N & Release: 9SA-USRS-9.0R1.02

SSHARK™ IAD User's Guide

Voice Module Tests

Monitor

Module

Exec

Circuit

VOICE-2
VOICE-3

VOICE-1

VOICE-1

2
3
4
5
6
7
8

1

1

Figure 11:

Diagnostics: Voice Module Tests Setup Page

Executing a Voice
Module Test

Set up your test using the following steps:
1. Select the module from the module pull down menu.
2. Select the circuit channel from the circuit pull down menu.
3. Click on the Exec button to display the signaling bits. The screen ouput will

display like shown in Figure 12. The labels of TA and TB identify that the
bits shown are for the Transmit A-Bit and Transmit B-Bit. The Labels of
RA and RB identify that the bits shown are for the Receive A-Bit and
Receive B-Bit.

test voice monitor voice-1 1

Voice-1 Channel 1 Signaling Bit Status:

Tx= 1111
Rx= 0000

Figure 12:

Display output of Voice Module Tests

D

IAGNOSTICS

:

P

ING

U

TILITY

The SHARK™ IAD has the capability to ping another IP address. Go to the
Ping Utility control page by clicking on the Diagnostics/Ping Utility buttons
from the Maintenance and Diagnostics page. Figure 13 shows the Ping Utility
setup page with all the options showing.