Verilink XEL XSP-100 SHARK IAP (9SA-USRS-9.0R1.02) Product Manual - Manual (Page 67)

Chapter 5: Graphical User Interface (GUI/WEB) Configuration Pages
SHARK™ IAD User's Guide XEL P/N & Release: 9SA-USRS-9.0R1.02 Chapter 5-13
character. Spaces are not allowed in the password field. Each password should
be written down and kept in a safe place. The system must be restarted before
the new passwords will take effect.
Note on default
password
considerations Leaving the passwords at the factory default may streamline the configuring
process because you may have to log on and off in the process of configuring
your SHARK™ IAD.
S AVE SYSTEM
SETTINGS
After entering all the parameters on this page, click on the save button to save all
the parameters in the system. The router must be "coldstarted" or power cycled
for the above settings to take effect. Once these new settings have taken affect
and you set the system passwords, a valid password must be entered to login into
the system thereafter. You may coldstart the router at this time or perform a
coldstart when you have completed the router configuration. See Figure 53 in
the "Router Review and coldstart" section on page 5-56.
S YSTEM T IMING &
V
OICE
Once the save button is pressed, the system returns to the IP/Routing
Configuration menu. Before continuing to provision the Router functions of
your SHARK™ IAD, go to the Home page by clicking on the Home button of
the navigation bar. Then click on the Config button of the system bar as shown
in Figure 9. The System Timing & Voice configuration page will appear as
shown in Figure 10.
XEL
SHARK
devi
ce ID
:xel
shar
k1000011
Home
Help
Status/
Alarms
Maintenance
XEL SHARK
device ID:xel shark1000011
XEL Communications Inc, 17101 East Ohio Drive, Aurora Co 80017
XSP 1OO Shark
TM
STATUS CONFIG INS
FXS
STATUS CONFIG INS
FXS
STATUS CONFIG
INS
FXS
STATUS CONFIG OOS
Xcon
STATUS CONFIG NPR
T1
STATUS CONFIG
INS
T1
CONFIG
STATUS CONFIG EMP
STATUS CONFIG
STATUS INS
Router
INS
Power
Supply
STATUS EMP
Module
STATUS
CONFIG
SHARK 010101000011
System
Point and Click on the "config"
button of the system bar
Figure 9: Home page selecting system config
S YSTEM T IMING :
S
OURCE
& M
ODE
Select the system-timing source by clicking the appropriate source. Table 6,
Figure 10 and Figure 11 describe the timing relationships associated for each
selection and show the possible timing affects.