Validating your configuration, Saving your configuration, Config commands – Verilink XEL XSP-100 SHARK IAP (9SA-USRS-9.0R1.02) Product Manual User Manual
Page 143: Configuration command verbs, Script, Router module specific considerations, Alidating, Onfiguration, Aving your configuration, Config commands -27

Chapter 6: Using the Command Line Interface (CLI)
SHARK™ IAD User’s Guide
XEL P/N & Release 9SA-USRS-9.0R1.02
Chapter 6-27
V
ALIDATING
Y
OUR
C
ONFIGURATION
You can use the valid CONFIG command to make sure that your configuration
settings have been entered correctly. When your enter the valid
command, the
SHARK™ IAD verifies that all required settings for all services are present and
that settings are consistent.
(top)>> valid
Error: Subnet mask is incorrect
Global Validation did not pass inspection!
You can use the valid command to verify your configuration settings at any
time. Your SHARK™ IAD automatically validates your configuration any time
you save a modified configuration.
S
AVING YOUR
CONFIGURATION
You must enter a save command before quitting out of the configurator to save
any changes you made during your configuration session. The new
configuration becomes effective upon entering the save command for all
modules except the ROUTER module. If changes were made to the ROUTER
configuration, a coldstart ROUTER or coldstart SYSTEM command must be
issued from the system root prompt to activate the changes. See the save
command on page 6-28.
CONFIG
Commands
Remember, you reach a particular module's configuration mode by typing
CONFIG
from the ROOT prompt:
SHARK010101000011> CONFIG
Then entering the module name exactly as shown in these examples:
(top)>> ROUTER
(top)>> VOICE-1
(top)>> TIMING
(top)>> trunk
C
ONFIGURATION COMMAND
V
ERBS
This is a linked list of all configurator command verbs.
Command Verb Page
SET
Sets configuration data. Use this command when entering keywords and their
arguments.
SCRIPT
Displays configuration setup script. When entered at the top node a complete
display of the entire configuration for all modules is displayed. When entered
from a subnode of the configurator's hierarchy, the configuration for that