Verilink XEL XSP-100 SHARK IAP (9SA-USRS-9.0R1.02) Product Manual - Manual (Page 213)

Chapter 9- Hardware Specifications
SHARK™ IAD User's Guide XEL P/N & Release: 9SA-USRS-9.0R1.02 Chapter 9-13
Router Module/CPU, 9SA-RTR0-V 01, 9SB-RTR0-V01
RS232
10/100 BASET
9SX-RTR0-000
LINK ACT
100 COL

XEL
Figure 8: Router Module Faceplate
G
ENERAL
DESCRIPTION
The Router Card is installed only in the SHARK™ IAD's router slot. The
MPC860T microprocessor chip mounted on this board is the central processor of
the SHARK™ IAD IAD. It provides all the control functions of the SHARK™
IAD. It has circuit connections to the Cross-Connect module and to the Local
Interface Modules (e.g. the 10BaseT module), and provides the SHARK™
IAD'S Craft Port and 10/100 Fast Ethernet interface. It provides the power-on
configuration for the IAD.
The Router card faceplate has a baud rate select switch for the 9-pin craft
interface connector. It also has the Mod 8 10/100BaseT connector, and four
indicator lights on it.
S
ERVICE
INTERRUPTION
NOTE
When the Router card is removed from the slot it will not interrupt services that
go from a WAN card to a Voice card, from a WAN card to a LAN card, from a
WAN card to a WAN card, or from a WAN card to a V.35 card.. Any service
using the ethernet port will be interrupted. Upon insertion of the Router card,
all services will be momentarily interrupted as the Router card will issue to
all cards a restart command and will also pass to all cards the configuration
data that the Router card holds.
H
ARDWARE
S
PECIFICATIONS
Physical size* Width: 4.25” Length: 12.66" Height: 1.0” Weight: 0.44 lbs
*All measurements include faceplate
Power Dissipation 3.5 watts maximum
2.3 watts typical
Environmental 0 to 50 ° Centigrade
Relative humidity 0-95%