beautypg.com

T1 module, 9sa-xc2t-v01, General description, Hardware specifications – Verilink XEL XSP-100 SHARK IAP (9SA-USRS-9.0R1.02) Product Manual User Manual

Page 221: Physical size, T1 m, Odule, 9sa-xc2t-v01 -21, Physical size* -21, Igure, Xc2t m

background image

Chapter 9- Hardware Specifications

SHARK™ IAD User's Guide XEL P/N & Release: 9SA-USRS-9.0R1.02 Chapter 9-21

T1 Module,

9SA-XC2T-V01

Figure 15:

XC2T Module faceplate

G

ENERAL

D

ESCRIPTION

The 9SA-XC2T-V01 card is a dual T1 interface and Cross Connect module that
may be inserted into the XCON slot on the front of the IAD.
The T1 interface consists of four wires in two pairs. These signal wires from the
T1 cable are physically terminated at a MOD-8 connector on the card’s
faceplate, which is wired as a RJ-48C T1 interface. Two Bantam jacks on the
card’s faceplate provides for monitoring both the receive T1 and the transmit T1
signal lines. A slide switch to the left of the monitor jacks determines which of
the two T1 circuits is connected to the jacks. Without an off position on the
slide switch, a T1 circuit is always connected to the monitor jacks.
This card provides for performance monitoring. See the Alarms and Monitoring
chapter for more details. Communication through the FDL link is supported
when the proper card is in a WAN position and programmed for ESF signaling.
See the FDL configuration in the Graphical User Interface Chapter or the
Command Line Interface Chapter.

H

ARDWARE

S

PECIFICATIONS

Physical size*

Width: 4.25”

Length: 12.66"

Height: 1.0”

Weight: 0.40 lbs

*All measurements include faceplate.

RX

9SA-XC2T-V01

TX

T1 MON

LO

C

RE

M

LP

BK

T1-1

T1-2

T1-1

T1-2

T1-1

T1-2

XEL