T1 configuration, Configuring the wan modules, Igure – Verilink XEL XSP-100 SHARK IAP (9SA-USRS-9.0R1.02) Product Manual User Manual

Page 77: Xample of, Wan1 t, Runk, Rocessing, Election, Wan1 trunk processing, Fxs ls— foreign exchange station loop start

Chapter 5: Graphical User Interface (GUI/WEB) Configuration Pages

SHARK™ IAD User's Guide

XEL P/N & Release: 9SA-USRS-9.0R1.02

Chapter 5-23

1. The connection from WAN1 slots 19 -24 to Router Ch1 slots 1-6 does not

need trunk processing because it is a data path.

2. The trunk processing for the connections from WAN1 to VOICE-1 and

VOICE-2 is configured in the VOICE-1 and VOICE-2 configuration pages.

Trunk processing must be defined for the remaining combinations of connections
made in this example. Refer to Figure 15 and use the page shown in Figure 19 to
configure these trunk processing connections. The page will only show the
following connections that require a selection for the trunk processing.

When using the XCON module:
1. The cross connections from WAN1 to LAN-1 or LAN-2.
2. The cross connections from WAN1 to WAN2.
3. The cross connections from WAN2 to LAN-1 or LAN-2.

When using the XC2T module:
1. The cross connections from WAN1 to LAN-1, LAN-2, T1-1, T1-2 or WAN2.
2. The cross connections from WAN2 to LAN-1, LAN-2, T1-1, T1-2 or WAN1.
3. The cross connections from T1-1 to T1-2, LAN-1, LAN-2, WAN1 or WAN2.
4. The cross connections from T1-2 to T1-1, LAN-1, LAN-2, WAN1 or WAN2.

Figure 19:

Example of WAN1 Trunk Processing Selection

Each circuit has a pull down menu with these options:

•

Clear Ch--Clear channel. No signaling bits used results in a full 64kbps band
width per channel (DS0). Examples of circuits are Voice Grade Data and
DDS Data. Do not use this selection if the DS0 is transporting a voice circuit
with A and B bit signaling as the signaling bits will not be placed into the
correct super frames.

•

FXS LS—Foreign Exchange Station Loop Start.

Save

Clear Ch

FXO GS

FXS GS

TMB on

wan 1

lan 1

Return to the Cross Connect page

View WAN2 Trunk Processing Configuration

Source

Trunk Processing

Source

Module

Src

Slot

Dest