beautypg.com

Option, Address, Broadcast – Verilink XEL XSP-100 SHARK IAP (9SA-USRS-9.0R1.02) Product Manual User Manual

Page 157: Netmask, Rip-send, Rip-receive, Tdm(x) vcc1 (ppp encapsulation), Peer -address, Tdm(x) vcc1 (ppp encapsulation) -41

background image

Chapter 6: Using the Command Line Interface (CLI)

SHARK™ IAD User’s Guide

XEL P/N & Release 9SA-USRS-9.0R1.02

Chapter 6-41

(top)>> ROUTER
(ROUTER)>> ip
(ROUTER ip)>>tdm1 vcc1
(ROUTER ip tdm1 vcc1)>>

If ppp was selected for the tdm-setup tdm(x) vcc(y) frame mode on page 6-36,
go to page 6-41 tdm(x) vcc1 (ppp encapsulation).

option

This command is configured in the same manner as in the fether configuration.

address

Use this command in the same manner as in the fether configuration above.

broadcast

Use this command in the same manner as in the fether configuration above.

netmask

Use this command in the same manner as in the fether configuration above.

nat

set nat option, where option = [ off | on ]: on
Turns network address translation on or off.

rip-send

Use this command in the same manner as in the fether configuration above.

rip-receive

Use this command in the same manner as in the fether configuration above.

tdm(x) vcc1
(ppp
encapsulation)

This command enters the tdm(x) vcc1 node to configure the tdm data pipe and
VCC. These commands must be configured when ppp is selected for the frame
mode
of the ip tdm(x) vcc1 parameters

(top)>> ROUTER
(ROUTER)>> ip
(ROUTER ip)>>tdm1 vcc1
(ROUTER ip tdm1 vcc1)>>

If frame-relay was selected for the tdm-setup tdm(x) vcc1 frame mode on page
6-36, go to the tdm(x) vcc(x) (frame-relay encapsulation) section on page 6-
40.

option

This command is configured in the same manner as in the fether configuration.

address

Use this command in the same manner as in the fether configuration above. This
can be 0.0.0.0 if the peer knows the SHARK™ IAD's IP address.

peer -address

set peer-address nnn.nnn.nnn.nnn This should be 0.0.0.0 unless the peer
does not know its own IP address.

nat

set nat option, where option = [ off | on ]:
Turns network address translation on or off.

rip-send

Use this command in the same manner as in the fether configuration above.

rip-receive

Use this command in the same manner as in the fether configuration above.