Status and alarms, Status & alarm submenu, Chapter 7: status and alarms – Verilink XEL XSP-100 SHARK IAP (9SA-USRS-9.0R1.02) Product Manual User Manual
Page 182: Status and alarms -2, Tatus, Larm, Ubmenu, Igure, Ome screen showing, Larms selection

Chapter 7- Status and Alarms
Chapter 7-2
XEL P/N & Release: 9SA-USRS-9.0R1.02
SHARK™ IAD User's Guide
STATUS AND
ALARMS
There are two ways to obtain a status report. Click on the Status/Alarms" button
of the navigation bar to access the Status and Alarms report menu. You can
access the status for any specific module by clicking its "status" button. Figure 1
shows both ways to obtain status.
XE
L SH
AR
K
device I
D
:x
el
sh
ark10
000
11
Home
Help
Status/
Alarms
Maintenance
XEL SHARK
device ID:xel shark1000011
XEL Communications Inc, 17101 East Ohio Drive, Aurora Co 80017
XSP 1OO Shark
TM
STATUS
CONFIG
INS
FXS
STATUS
CONFIG
INS
FXS
STATUS
CONFIG
INS
FXS
STATUS
CONFIG
OOS
Xcnct
STATUS
CONFIG
NPR
T1
STATUS
CONFIG
INS
T1
CONFIG
STATUS
CONFIG
EMP
STATUS
CONFIG
STATUS
INS
Router
INS
Power
Supply
STATUS
EMP
Module
STATUS
CONFIG
SHARK 010101000011
System
Point and Click on the
"Status/Alarms" button of the
main navigation bar or on the
"Status" button of any module.
Figure 1:
Home screen showing Status/Alarms selection
S
TATUS
& A
LARM
S
UBMENU
Click on the Status/Alarms button of the navigation bar. Figure 2 shows the
Status and Alarms submenu. This submenu has four reports to display:
•
Show Alarms button: Clicking on this button will display a full report of any
current alarms conditions or tests in progress. If an Alarm is present this
report will list the module(s) in alarm and the type of alarm. See Figure 3
•
General System information: Figure 4 shows a typical report.
•
System Event Log shows the most recent entries in the diagnostic log.
Figure 5 shows a typical report.
Status and Alarms
Show Alarms
General System Information
System Event Log
Mark all log events as NEW
Figure 2:
Status and Alarms submenu