Verilink XEL XSP-100 SHARK IAP (9SA-USRS-9.0R1.02) Product Manual - Manual (Page 94)

Chapter 5: Graphical User Interface (GUI/WEB) Configuration Pages
Chapter 5-40 XEL P/N & Release: 9SA-USRS-9.0R1.02 SHARK™ IAD User's Guide
TDM VCC Type
selection
(Frame Relay
Encapsulation)
Once the save button is pressed, the SHARK™ IAD TDM configurator
automatically accesses the TDM Channel 1 VCC Setup selection page. Figure
36 shows the options for a frame relay TDM VCC definition. Use this page to
define either a direct or Ethernet (also known as Bridging) type of VCC. Also
select whether to use q922 control or not and the local Data Link Connection
Identifier (DLCI). The DLCI is the frame relay virtual circuit number
corresponding to a particular destination. The DLCI is part of the frame relay
header.
Save
direct
q922
Click on the arrow to select
from these additional options
direct
ethernet
direct
q922
none
q922
TDM Channel 1 VCC Setup
Channel 1 VCC 1 Setup
Type
Control
Local DLCI 40
Figure 36: TDM Channel VCC Setup (Frame Relay Encapsulation)
The DLCI is used in a frame relay application to identify the data link and its
frame relay service parameters. The DLCI defines the frame size, Committed
Information Rate (CIR), Committed Burst size (Bc), Burst Excess Size (Be) and
Committed Rate Measurement Interval (Tc).
•
Select VCC type: direct or ethernet. Most common is the default of direct
•
Select VCC Control: q922 or none. Most common is the default of q922
•
Enter the Local DLCI #: 0-1023.
•
Press the save button.
This page is the last configuration page for Frame Relay encapsulation in the
TDM configurator. Pressing the save button returns you to the TDM
Configuration selection screen on page 5-37.
PPP Channel Select Page If you have selected PPP as encapsulation for a particular TDMs VCC, the PPP
channel enable page will appear once you click on the save button of the TDM
Channel
configuration page. Figure 37 shows the Channel setup page for PPP
encapsulation. Enable the VCC by clicking on the on button. Then click on the
save
button.