beautypg.com

Trace ppp, Trace pppdump, Trace frmr – Verilink XEL XSP-100 SHARK IAP (9SA-USRS-9.0R1.02) Product Manual User Manual

Page 137: Trace scon, Trace ipmap, Update, Introduction to the configurator, Trace ppp -21 trace pppdump -21 trace frmr -21, Lmi -21 arp -21, Trace scon -21 trace ipmap -21

background image

Chapter 6: Using the Command Line Interface (CLI)

SHARK™ IAD User’s Guide

XEL P/N & Release 9SA-USRS-9.0R1.02

Chapter 6-21

TRACE PPP

to toggle tracing of PPP flow

TRACE PPPDUMP

to toggle tracing of PPP packets

TRACE FRMR

followed by

LMI

to toggle FRMR lmi trace

ARP

to toggle FRMR arp trace

TRACE SCON

to toggle tracing of SCON scripts

TRACE IPMAP

to toggle tracing of IP Mapping

UPDATE

to download specific firmware from the SHARK™ IAD's library to a target slot
update where is the module name (use "lib slot" to view
allowed names)

WHO

Displays the name and hostname of the current shell users

INTRODUCTION TO THE CONFIGURATOR

The following paragraphs discuss the CONFIGURATOR (CONFIG). When
you enter the root command config SHARK™ IAD configurator. This is called
the CONFIG mode. You must enter the CONFIG mode first to configure each
module. Studying these paragraphs will help you use the configurator in a
timely and efficient manner.
You enter the configurator by typing

CONFIG

(or just C) from the ROOT prompt:

SHARK010101000011> CONFIG

Then entering the module name exactly as shown:
module name = [ROUTER | TIMING | VOICE-SYS | WAN-1 | WAN-2 |
LAN-1 | LAN-2 | XCON-1 | XCON-2 | trunk | VOICE-1 | VOICE-2 |
VOICE-3 | XC2T ]
As shown in these examples:

(top)>> ROUTER
(top)>> VOICE-1
(top)>> TIMING
(top)>> trunk

See
Table 2 on page 6-23 for configurator command usage guide lines.

Figure 6 shows the format of the configurator prompt and how to enter configure
commands.