Verilink XEL XSP-100 SHARK IAP (9SA-USRS-9.0R1.02) Product Manual - Manual (Page 49)

Chapter 4. User Interface Hardware Connections
SHARK™ IAD User's Guide XEL P/N & Release: 9SA-USRS-9.0R1.02 Chapter 4-5
L OGIN TO YOUR
SHARK™ IAD
The SHARK™ IAD is sent from the factory with default passwords set. These
default login names and passwords are as follows:
Login Name Password
admin
password
system password
user password
Refer to the detailed instructions on passwords and logging in found in the GUI
and CLI configuration chapters. Proceed to login to your SHARK™ IAD by
following these steps:
Incorrect Login
Lockout and
restore. The Telnet connection and the RS232 Craft port have a lockout that occurs after
3 failed login attempts. A failed login occurs when the login process does not
return the Shark prompt. The port will not respond to attempts for login for 10
minutes after the third login failure. Each connection or port is treated
independent of the others. If a login attempt fails on a port, the other port and
concurrent sessions, if applicable, will not be affected. The counting of failed
logins will reset to 0 if the Router performs a Coldstart feature, the power to the
Router is temporarily interrupted or a proper login occurs on that port or session.
If another login is not attempted nor any characters sent after the first or the
second failed tries, the counting of failed logins will be set to 0 when the
Keyboard Inactivity Logout timer expires.
Keyboard inactivity
logout timer. A Telnet or RS232 Craft port will be logged out of a connection if the connected
terminal does not send any characters for a period of time that is depicted by the
inactivity timer. The inactivity timer may be set from 0 to 10 minutes in one
minute increments. A setting of 0 minutes defeats the timer and the port does
not log out.
Set your WEB
Browser to "NO
CACHE" and “NO
SEARCH”. To insure the proper operation of The SHARK™ IAD's real time GUI interface,
disable the page saving feature or "CACHE" of your WEB browser. You may
also need to turn off the feature of searching from the address line. Please refer
to the instructions for your particular WEB browser for performing this task.
Proceed to log into your SHARK™ IAD.